Car Fob Battery for Chevy Equinox 2013: Deluxe CR2032
The remote key fob on a Chevrolet Equinox of this generation runs on one CR2032 3V lithium coin battery. It is 20mm wide and 3.2mm thick. This Deluxe pack includes two cells: one for the fob and one spare.
This page contains affiliate links. We may earn a commission if you buy through them, at no extra cost to you.
Will This Battery Work in Your Equinox Fob?
Chevrolet’s Equinox instructions call for a CR2032 or equivalent battery in the remote key fob, and a repair guide for 2010 to 2013 Equinox fobs also points to a CR2032. The Deluxe listing describes its cells as 3V CR2032 batteries. Run this quick check before you buy.
An aftermarket or replacement fob may use a different design or battery. Always check the marking on the battery already inside your fob. The pack does not include a key fob.
Deluxe CR2032 Specifications
| Property | Detail |
|---|---|
| Brand / model | Deluxe Batteries, Key Fob Battery for Chevy GMC (CR2032) |
| Amazon ASIN | B0D53P8QV4 |
| Pack contents | 2 batteries (key fob not included) |
| Battery type | CR2032 lithium coin cell, single use |
| Chemistry (CR2032 format) | Lithium / manganese dioxide (Li/MnO₂), non-rechargeable |
| Nominal voltage | 3 V |
| Dimensions (standard CR2032) | 20 mm diameter × 3.2 mm thick |
| Listed capacity | 225 mAh (from the product listing) |
| Rechargeable | No |
| Intended use | Replacement battery for compatible Chevrolet and GMC key fobs |
| Weight, shelf life, temperature range | No verified data found for this product |
The 225 mAh capacity comes from the product listing and has not been independently tested. Capacity changes with load, temperature and device cutoff voltage. Size and chemistry describe the standard CR2032 format.
Equinox Fob Battery Replacement Difficulty
This is a beginner-level job on an intact fob. No soldering is involved, and the battery slides out of its holder. The hardest part is separating the two halves of the fob without damaging them, since these remotes can be tricky to open. Tap a slice to highlight it.
- 40% Separating the fob halves
- 20% Choosing the right battery
- 15% Swapping the cell
- 25% Seating & testing the fob
Difficulty score and effort split are an editorial estimate based on Chevrolet’s published steps and a 2010 to 2013 Equinox repair guide, not an official rating.
How to Replace Your Equinox Key Fob Battery
Tap each step to tick it off as you go. Avoid touching the circuitry inside, because static from your body can damage the transmitter.
- 1Release the keyPress the button on the side of the transmitter and pull the key out.
- 2Separate the two halvesInsert a flat tool into the area near the key slot and gently separate the two halves of the transmitter.
- 3Remove the old batteryPush on the battery and slide it toward the bottom of the transmitter. Keep it away from children and pets.
- 4Insert the new CR2032Place the new battery with the positive (+) side facing the back cover. Push it down until it is held in place.
- 5Snap the cover back onPress the two halves together until they snap shut, then put the key back in and test the buttons near the vehicle.
Check that the cell is fresh, that the positive side faces the back cover and that it is held firmly in place. If the fob still fails, have it checked.
Other Devices That Use a CR2032
The CR2032 is a common coin cell used across small electronics. Only use it where the device manual calls for a CR2032.
- Car key fobsOnly CR2032 models
- Keyless entry remotesCheck the existing cell
- Card remotesCompact transmitters
- CalculatorsCR2032 models only
- WatchesCR2032 models only
- ToysCheck your manual
- Fitness trackersCheck your manual
- Medical instrumentsCheck your manual
- Memory backupHolder type must match
- Price tagsRetail & security tags
- Transmitter tagsSmall transmission tags
Safety, Storage & Disposal
A lithium coin battery lodged in the throat can cause serious burns in as little as two hours. Do not wait for symptoms and do not induce vomiting. Get emergency medical help immediately and call a poison center if you suspect a child swallowed a cell.
- Never recharge, take apart, deform, heat or burn a CR2032.
- Keep new and used cells away from children at all times.
- Store spare cells away from metal objects such as keys and coins.
- Dispose of used cells at a battery collection point, following local rules.
Equinox Key Fob Battery: FAQ
What battery does a 2013 Chevy Equinox key fob take?
The remote key fob uses one CR2032 3V lithium coin cell, installed with the positive side facing the back cover.
Does the 2-pack mean the fob uses two batteries?
No. The fob uses one battery. The second cell in the pack is a spare.
How long does the battery last in a key fob?
No verified in-fob service life is published for this product. Runtime depends on how often you use the fob, temperature and the age of the cell.
Is the Deluxe CR2032 rechargeable?
No. It is listed as a single-use battery, and CR2032 cells must never be recharged.
Can I touch the circuit board when changing the battery?
Avoid it. Chevrolet’s instructions warn that static from your body can damage the transmitter, so do not touch any of the circuitry.
What if the fob still does not work after a battery change?
Check that the cell is a fresh CR2032, that the positive side faces the back cover and that it is held firmly in place. If the fob still fails, have it checked.
